To make things easier for you, the front of the board is the opposite side from the one with the 4in1 ESC port. You can refer to the connection diagram for the proper flight controller placement. There is no visual clue about the flight controller orientation. VBAT up to 6s with voltage regulator 2.5A continuous 3.2A burst. Voltage sensing up to 26V, current and RSSI inputs (3.3V max). UART1 and UART2 have inverters for S.Bus and SmartPort telemetry.ĭedicated port for 5V (100mA max) buzzers. Built-in inverter for FrSKY telemetry.ĥ full serial ports (UARTs). PPM, S.Bus (inverter built-in), DSM, HoTT, SRXL, CSRF, FPort ready. 5V or 3.3V supply for receiver.įrSKY Smart Port, FrSKY Sensor Hub, HoTT Telemetry, SRXL, CSRF, FPort ready. Also, there are separate bridges available after the 4in1 connector that enable you to select the proper 4in1 voltage output and current sensor, for powering the board through the 4in1 ESC. The bridges on the board are a very neat feature that enables you to choose how you want to power the board. There are several bridged connections on the Helio RC Spring flight controller. The Helio RC team has taken care to mark everything properly on the new Helio RC Spring AIO board intended for pilots that prefer four separate ESCs. For the ones that are not marked, you will have to look at the connection diagram. There are visible markings on almost all pads.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |